Rack / Herpstat help!

[Albert Clark]

I would try moving the probe to another location than the pre set location on a trial basis and monitor the temps from there. Make sure to only put tape over the probe wire and not the probe itself though.

[Stearns84]

I would try moving the probe to another location than the pre set location on a trial basis and monitor the temps from there. Make sure to only put tape over the probe wire and not the probe itself though.

I'm sorry, what do you mean the probe wire only, and not the probe?

Thanks

[Albert Clark]

The probe sensor is the end and larger part of the wire. You shouldn't be putting tape over the sensor part. Tape behind the sensor but make sure that the sensor is flush and less than one quarter inch away from your heat tape.

[Albert Clark]

I'm sorry, what do you mean the probe wire only, and not the probe?

Thanks

My mistake, i meant to say sensor. Don't tape over the sensor. Sorry.

[For Goodness Snakes]

Can you show us a photo of your thermostat's probe location?

Thanks

Brian

[Stearns84]

I'll snap a few pictures tonight when I get off of work for you guys.

Thanks again for all your help with everything!