Vote for BP.Net for the 2013 Forum of the Year! Click here for more info.

» Site Navigation

» Home
 > FAQ

» Online Users: 766

1 members and 765 guests
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.

» Today's Birthdays

None

» Stats

Members: 75,905
Threads: 249,104
Posts: 2,572,101
Top Poster: JLC (31,651)
Welcome to our newest member, Pattyhud
Results 1 to 3 of 3
  1. #1
    Registered User
    Join Date
    12-15-2015
    Posts
    115
    Thanks
    16
    Thanked 11 Times in 11 Posts

    Heating through plexiglass?

    So I ran into a major problem with my smaller tank. My RHP is a half a inch too big to get inside of my tank. I have a piece of plexiglass for the lid of it that was meant for the panel to be bolted to. My options are to, buy a bigger thank (and a bigger piece of plexiglass), buy a smaller RHP (but it would be wasted once this BP is ready for a bigger room). Or buy a CHE.

    Question is, Would a t-stat regulated CHE be too hot to use over 1/4" plexiglass with holes drilled in it around the element? The room's ambient temp is 75 so the CHE only needs to get the tank's ambient up 5 degrees.
    Last edited by HanabiraAsashi; 03-07-2016 at 08:30 PM.

  2. #2
    BPnet Veteran Yodawagon's Avatar
    Join Date
    09-04-2015
    Location
    Minnesota
    Posts
    612
    Thanks
    2
    Thanked 231 Times in 157 Posts
    I would just get the smaller panel.

  3. #3
    BPnet Veteran
    Join Date
    02-02-2016
    Location
    Boston Area
    Posts
    671
    Thanks
    197
    Thanked 572 Times in 308 Posts
    Images: 1
    What kind of RHP? I have a Reptile Basics 80w panel on the lid of a 20L. The panel is tapered from the emitting part to the edges, so the emitting part actually does fit inside the tank and the edges sit on the edges of the tank, if that makes sense. I added a few wooden blocks to lift the rest of the lid just a little higher, so now the panel nests very nicely. The lid sits up higher, on the blocks. (It's held on with a luggage strap, because I was too lazy to rig up any more elegant latching system)
    An additional benefit is that there's actually a little ventilation most of the way around the edges of the top, so I was able to completely cover the screen. With the ventilation at the sides of the lid instead of on the top, the humidity stays much better.

    Sorry if it's hard to describe; I'll try and get a photo tomorrow... but basically, this took me all of 20 minutes to assemble and that counts the time it took to go find the wood.

    But basically, the lid is set up on blocks so the panel is higher, and it nests in very nicely. The panel is still low enough that it would stop the snake from being able to slide the lid off if he tried. This setup would NOT work for something like a baby corn snake, which would totally be able to shinny up the corner and squeeze out of the gaps (although even that could be corrected fairly easily if necessary). But not a BP, even a very small baby.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.2.1