» Site Navigation
2 members and 1,478 guests
Most users ever online was 9,191, 03-09-2025 at 12:17 PM.
» Today's Birthdays
» Stats
Members: 75,868
Threads: 249,062
Posts: 2,571,950
Top Poster: JLC (31,651)
Welcome to our newest member, elizard
|
-
Q for those housing boas or other large snakes in PVC cages
Hi guys!
Although I have a varied small collection (9 now with #10 on the way)... I have decided that boas are the direction I'm going. I currently have 2 males (BCI and BCA), just ordered a CA Motley male, and have plans (in the next 2 years or so) to acquire a breeding pair of Nicaraguans or BCLs... That said, this is obviously a more expensive direction for me to go with my collection housing-wise.
For those with multiple cages, what brand have you found to be the most economical, yet quality? Is is cheaper to buy a pre-fab unit of multiple cages (i.e. proline) or just collect as you go?
And, given 2 cages with the same heating setup (flexwatt, etc.) do you ever run them on the same thermostat channel?
I will more-than-likely be looking for sliding glass doors (with locks) and belly heat (the room is heated so I do not need RHPs). What will make it expensive, is the height I want.. I'm planning on 4'x2'x 18", which bumps of the cost quite a bit when dealing with any of the cage makers.
I'd appreciate any opinions from those that have multiple cages.
Thanks for your time / help!
Currently keeping:
1.0 BCA 1.0 BCI
1.0 CA BCI 1.1 BCLs
0.1 BRB 1.2 KSBs
1.0 Carpet 0.5 BPs
0.2 cresteds 1.2 gargs
1.0 Leachie 0.0.1 BTS
-
-
My male sunglow is in a T8(48"x24"x12") from animal plastics. I have my other snakes in these as well. I have found them to be very well made and great enclosures. Any specific reason you want 18" in height? Mine are 12" and they are quite roomy. I still have room to put in climbing branches for him.
-
-
Thanks for the reply!
I was wanting the 18" for 2 reasons.. I did want climbing space, either a shelf or tall enough for climbing branches, etc. But I have also heard that the 12" tall ones are very hard to clean vs. the taller cages.
Currently keeping:
1.0 BCA 1.0 BCI
1.0 CA BCI 1.1 BCLs
0.1 BRB 1.2 KSBs
1.0 Carpet 0.5 BPs
0.2 cresteds 1.2 gargs
1.0 Leachie 0.0.1 BTS
-
-
Animal plastics. Maybe take a look at the T10, 15 high and $130 less than the 18 tall T11. I keep large carpet pythons in these. But if 18 inches is a must, I still say AP.
-
-
Thanks!
The AP cages do look like a good deal. But when I played with the cart... Even the T8 (with a light fixture, heat tape, and lock) ended up costing almost $300... I played with the cart some more and added another cage and set of accessories to see if that would help on shipping costs, but apparently you don't get a break on shipping when you buy more than one cage at a time.
I may have to look into a seller that comes to a show near me... Maybe getting a cage delivered will at least save on shipping (I think the shipping for AP was $60 per cage).
If 15" is tall enough, then I could use one that tall... I have a Jaguar male Carpet that will need a cage as well. Do you have a pvc perch in there for him or a shelf?
Currently keeping:
1.0 BCA 1.0 BCI
1.0 CA BCI 1.1 BCLs
0.1 BRB 1.2 KSBs
1.0 Carpet 0.5 BPs
0.2 cresteds 1.2 gargs
1.0 Leachie 0.0.1 BTS
-
-
Registered User
Re: Q for those housing boas or other large snakes in PVC cages
Last edited by davidjleggett69; 03-12-2015 at 08:01 AM.
Reason: Not an answer I was dropping my phone lol
-
-
Re: Q for those housing boas or other large snakes in PVC cages
 Originally Posted by artgecko
If 15" is tall enough, then I could use one that tall... I have a Jaguar male Carpet that will need a cage as well. Do you have a pvc perch in there for him or a shelf?
I don't use perches or shelves, though you could certainly fit one into the T10
-
-
I agree with DennisM, check out the AP T-10 cage. Its plenty high and can put a shelf in to give in essence even more floor space. I personally am using a Pro-Line 48x23x14 HDPE cage now for my 6ft BCI but I will probably give AP cages a try as I've heard great things about them and their customer service responses are quick.
0.1 Rio Bravo Pokigron Suriname BC-Gina
1.0 Meltzer/Lincoln Peruvian Longtail het anery BCL-Louie
0.1 Biak Green Tree Python-Pat
1.0 OSHY Biak Green Tree Python-Alex
0.0.1 Super Reduced Reticulated Gila Monster-Dozer
0.0.1 Utah Banded Gila Monster-Tank
0.0.1 Super Black Beaded Lizard-Reggie
-
-
-
-
I think any well known companies pvc cage is going to run 3-400 once you add heating and lighting or whatever you need. I've seen up and coming people making snake cages for less, but there's a noticeable quality drop as far as appearance too. I have boaphiles and they were not cheap but factored into the life of my snakes, and keeping them healthy seems more than worth it.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|