Finally!!

[T_Sauer]

I hope you're going to put some holes in those tubs....

Why???? .... I have several rack systems that do not require holes in the tubs .... It all depends on how the rack is built ... It is up to the handler to monitor the humidity and find out how many, if any, holes are required to reach your desired humidity ... Size of gap where the tub meets at the top, size of heat tape, and room the rack is in all come into factor for this .... Sometimes holes simply are not required

[Rickys_Reptiles]

Why???? .... I have several rack systems that do not require holes in the tubs .... It all depends on how the rack is built ... It is up to the handler to monitor the humidity and find out how many, if any, holes are required to reach your desired humidity ... Size of gap where the tub meets at the top, size of heat tape, and room the rack is in all come into factor for this .... Sometimes holes simply are not required

There are lids on the tubs. If there are no holes how are the snakes going to get air?

[C2tcardin]

Why???? .... I have several rack systems that do not require holes in the tubs .... It all depends on how the rack is built ... It is up to the handler to monitor the humidity and find out how many, if any, holes are required to reach your desired humidity ... Size of gap where the tub meets at the top, size of heat tape, and room the rack is in all come into factor for this .... Sometimes holes simply are not required

I think, and I'm not trying to speak for someone else, it was because the tubs all have lids on them. I noticed the same thing but figured she may have done the same thing I do and that's to put the holes running along the side of the tubs, not the front facing portion of the tub. I like it this way as it looks cleaner to me not seeing the holes.

[T_Sauer]

Congrats on the new rack! .. I remember when I finally switched over to racks ... SO MUCH EASIER!!!

[megan8706]

I think, and I'm not trying to speak for someone else, it was because the tubs all have lids on them. I noticed the same thing but figured she may have done the same thing I do and that's to put the holes running along the side of the tubs, not the front facing portion of the tub. I like it this way as it looks cleaner to me not seeing the holes.

Yes, my holes are down the sides simply because I don't like the look of the holes in the front, just my personal preference though


Sent from my iPhone using Tapatalk

[T_Sauer]

There are lids on the tubs. If there are no holes how are the snakes going to get air?

Good observation lol ...... I didn't notice there were lids on them at my first look, but you are correct ... Therefore making your previous statement perfectly justified .... That's what I get for jumping on here before I fully wake up haha

[megan8706]

See guys, no harm here!


Sent from my iPhone using Tapatalk

[megan8706]

Here's the male before I put him up.


Sent from my iPhone using Tapatalk

[C2tcardin]

See guys, no harm here!


Sent from my iPhone using Tapatalk

Looks a bit too humid, unless of course that's intentional for a soon to be shedding snake. I usually add more holes to mine when I see that much condensation. Just my $.02 though.

[megan8706]

Looks a bit too humid, unless of course that's intentional for a soon to be shedding snake. I usually add more holes to mine when I see that much condensation. Just my $.02 though.

I'm still in the process of getting them set up properly, but I plan to add more holes, I'd rather start out with too few and be able to add more if needed than to start out with too many


Sent from my iPhone using Tapatalk