Quote Originally Posted by bcr229 View Post
Somewhere there should be a small access hole near the back end of the rack so that you can insert the probe. I sandwich it in between the tape and the rack itself, in a spot where it won't be easily dislodged and where it won't interfere with the tub sliding in and out.

Bear in mind that the temperature at the probe probably won't be the same as the belly heat. I start mine at 90*F, let it run for an hour, then use an IR thermometer to check the temperature of the tub on the hot side, and adjust the thermostat setting up or down as needed.
So the rack on the bottom, then probe, then tape? Just want to make sure I got that right lol.

How do you position yours so it doesn't interfere with the tubs sliding in and out? Can you tape or glue them down somehow or no? I feel like with all the heat that's probably not a good idea.

Thank you for your help!