Hello everyone I'm hoping you guys will be able to help me out with my RHP. Soooo I've had my Proline cage with Pro Products heat panel set up for a couple months and I love the heat panel but I'm having some problems with my Herpstat. I knew I would have to fiddle around with a set temperature so I could get the perfect gradient and that Was 77.5. But this is where the issue is once it's set to 77.5 my Herpstat turns the heat panel on/off instead of dimming it (which it is set to I've check like a gazillion times! Lol) also when it turns it on it will keep it running at 100% power for a couple hours which makes the heat panel go up to 170 degrees and makes the hotside wayyy to hot! The top of the hide will measure 100+ while the substrate will be at like 95 which is too hot in my opinion. So basically the Herpstat is running my heat panel at either 0% power or 100% power very scarcely does it actually regulate the heat between 0-100. I also have a small rack plugged into the other input but it regulates the heat tape in the rack perfectly using 40% power. So I'm not really sure what's going on or if it's supposed to do this. I haven't had my heat panel for very long so when it gets really really hot it freaks me out. But hopefully you guys can help me out what in the world should I do about this?


Sent from my iPhone using Tapatalk