Got around to making my cuts and partially constructing the cage yesterday. cutting fiberglass is tricky, so I ended up scoring it with a utility knife and using pliers to snap off the section along the scoring. This is what it looks like assembled:

It's looking very clean, I'm pleased with it. I will be picking up corner and L brackets to hold it together though. My original plan was to use silicone adhesive, but I think the brackets will be more sturdy and effective in the long run.

the front panel has been the trickiest part. my original plan was to cut door sections into the fiberglass, but because of the scoring technique I had to use to trim, I no longer think that will work. I'm considering making a rudimentary track system and having two sliding panels as access points to each half of the cage.

I still need to drill ventilation holes into the back panel, and the front once I decide on the opening mechanism.

Sent from my warm hide using Tapatalk