Yeah, i've been looking more closely at it, and I do believe that it would still be more consistent as you can set the point at which the heater comes on at off at 0.5 degrees above or below the specified temperature. That comes out to a little less than 1 degree fahrenheit under/over the set point. Compared to the +- 2 fahrenheit with the hydrofarm.
After more research I think that a PID controller would be a better option. Using one such as those listed on amazon should give me the most consistent heating. It seems reasonable that people use those PID controllers with the Solid State Relays to control anything from microbrew fermentation to furnaces. These seem like they might be the most ideal as they are proportional and take that one step further and use logic to minimize the error in heating and anticipate the overshoot in temperature that is a problem with a regular thermostat. Even better is that the SSR use no moving parts and will not have the same clicking that the hydrofarm does when the relay opens and closes. Admittedly my knowledge is limited but I think I will purchase one and make a post on how I wire it and how well it works.
I decided a while back that I want double redundancy for heating safety and Ill use the hydrofarm set to say 95 so that even a failure of the PID will not result in any harm to my reptiles







Reply With Quote