I'd check out the caging forum and DIY forum in general husbandry and supplies. You'll definitely find your answer there. I've been lurking around there to find more info about building a wooden terrarium myself.
Sent from my SAMSUNG-SGH-I747 using Tapatalk
0.1 Reg. BP Het. Albino (Faye),
1.0 Albino BP (Henry),
0.1 Pastave BP Het. Pied (Kira)
1.0 Pied BP (Sam)
1.0 Bumble Bee BP (Izzy)
Buy a piece of Flexwatt or THG and secure it to the inside of the bottom with aluminum tape. Then cover the entire floor of the enclosure with a piece of linoleum. Secure the linoleum to the floor and seal the edges with silicone.
Or, if you have access to a router, buy a single piece of ceramic floor tile from Lowe's or Home Depot. Cut the tile, if necessary, to your desired size. Cut an opening in the bottom of the enclosure so that an inch or so of tile overlaps the hole on all four side. Use the router to cut a recess the thickness of the ceramic tile just wide enough so the tile drops in flush with the floor. Drop the tile onto the remaining lip and secure with silicone. Also use silicone to seal any minor gaps on the edge. Your heat mat or Flexwatt/THG will then attach to the bottom of the tile with aluminum tape.
Good luck on the build!
0.1 Desert Yellowbelly BP | 0.1 Yellowbelly BP
0.1 Pastel BP | 1.0 Super Pastel BP
0.1 Champagne Het Hypo BP | 0.1 Spider BP
0.1 Lesser BP | 0.1 Pinstripe BP
1.0 Caramel Albino BP
1.0 Butter BP | 1.0 Pied BP
1.0 Cinna Bee BP | 1.0 Albino BP,
2.1 normal BP's
2.1 Western Hognose Het albino | 1.0 Western Hognose Albino Het Axanthic
1.0 Anaconda phase Western Hognose
1.0 BCI Boa |0.1 Hypo Het Snow Boa
0.1 Hypo Boa | 0.1 Hogg Island Boa
0.1 Striped Borneo Short Tailed Python
0.0.1 Jayapura GTP
Reply With Quote
