Hey everyone...here is my problem...
I just finished setting up ny new vision cage for my BP and I cant seem to get any of the settings right. My temp is too low and humidity is too high. My setup is as follows:
Vison cage 211
UTH on thermostat
1/3 inch substrate
Hide and water dish on seperate side of the tank
Thermometer with probe at the top back end of tank (so its not near the UTH)
Hydrometer with the probe at the other side of tank top end.

I have my thermostat set to 105 and the reading from my heat pad through the substrate is 78.9 everywhere else in the tank is at 72...humidity is at 82% which is way too high...I havent even misted it. The enclosure has been set up for 2 days. Will this stabilize? If not how do I lower the humidity? Are my probes in the wrong spot? Also the temp in my house is steady at 75 the tank is away from any air vents. Here are the pics of my setup.


Sent from my SAMSUNG-SGH-I747 using Tapatalk 4 Beta