Both mine did it haha I need a sharper bit for the first hole. Will super glue along the top work good? An do I make extra holes in the sides or is the one in top good?
Mike ya I'm getting the screen tops from skulls an using baseball holders
Normals 1.3
Spider .1
Carpet Python .1
Dog APBT .1
can you tell what kinda wood this is I can't member at all, idk if pine is bad for Ts or if I can use this kinda wood an cut it down to size just for the hide since now bunch of snow on the ground
Normals 1.3
Spider .1
Carpet Python .1
Dog APBT .1
Is that a 2x4?
I think they are made from soft woods like spruce or pine. I would think they are safe after being through the kiln.
Now I'm not sure if they have any chemicals on it.
1x3 an I know it's kiln dried an nothing else added I get the long untreated pieces to use for my wood working stuff from the lumber yard. Ill cut them down an each will have a hide an ill be set
Normals 1.3
Spider .1
Carpet Python .1
Dog APBT .1
rose's golden's I still need a cap for the water for the golden but it's gonna go same spot. It's fine to put them on top of it all or should I get smaller ones to fit by the entrance to the little hide I put in. The substrate is most enough i can burrow in it an it holds ill mist it before i add them. Any changes I should make?
Normals 1.3
Spider .1
Carpet Python .1
Dog APBT .1
Looks good.
If they don't like something, they'll start moving things around :p
One I like to do for both of these types. I'll give them a dry spot so they can have a choice. At their size they need the humidity up but both species like a dry substrate.
At 2" you'll start to slowly move them over to completely dry substrate.