....again.
Ok. So I'm working on some new roach racks and a shelf system for my King Snakes.
Each shelf will have its own piece of heat tape.
So when a doing project that doesn't have one long strip of heat tape snaked through. There is always going to be the risk of failure right?
To be 99% safe you would need a probe on each section of heat tape, right..?
Even if it was snaked through as one piece there could be a failure on slot 2 if the probe was on slot 5. Looking at this right, or no?
I have been very busy so my mind might be playing tricks on me. :o
Thoughts?