» Site Navigation
1 members and 841 guests
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.
» Today's Birthdays
» Stats
Members: 75,899
Threads: 249,095
Posts: 2,572,066
Top Poster: JLC (31,651)
|
-
BPnet Veteran
Antifungal powder
Ugh, two of my eggs are molding on their "imperfection spots". They have nice veining, and look alright otherwise. Which brand do you all recommend, or do you recommend something different than antifungal powder?
The one that has the obvious spot on it and the one above it are the ones growing mold.
-
-
BPnet Veteran
I have never had any luck with the powder stopping the mold. I have also never lost any other eggs due to mold spread. I used tinactin (sp). The mold stopped at the bad eggs. I might be me but I don't see mold on your eggs. The mold I have gotten has been Green and smelly.
-
-
BPnet Veteran
Axeman, you're right, this pic was the day they were laid. They are now on day 9. The mold on them is greenish, not smelly as far as I know. I am not worried about mold spreading, I am worried about the mold killing these two eggs that are so obviously fertile.
-
-
BPnet Veteran
I've never had a good egg mold. How are your temps and humidity? Is there any water dripping down onto the eggs at all? You could certainly try the powder and see if it helps.
-
-
BPnet Veteran
-
-
BPnet Veteran
-
-
The eggs look like they are too wet to me. Have you considered putting some egg crate into the tub to lift the eggs out of the substrate?
http://www.homedepot.com/p/24-in-x-4...6#.UVEOZr_qo_s
I wouldn't put anti-fungal powder into the tub, or on the eggs. Just get them out of the wet substrate and see if that resolves this issue.
~Aaron
0.1 Pastel 100% Het Clown Ball Python (Hestia)
1.0 Coastal/Jungle Carpet Python (Shagrath)
0.1 Dumeril's Boa (Nergal)
0.1 Bearded Dragon (Gaius)
1.0 Siberian Husky (Picard)
0.1 German Shepherd/Lab Mix (Jadzia)
-
-
Registered User
I use Lotrimin athletes foot powder. It usually stops the growth with just a small application.
-
-
Phew, you need to give us some time to answer! One thread is plenty, plus you want breeding questions to go here, the picture sub forum gets flooded every day all day and your thread will only show for a day on that page.
As for the eggs, you have them too wet. I would get them off the substrate asap so you don't have to deal with that anymore. It's so much easier to go substrateless, you don't have the headache of trying to figure out how wet it needs to be. All you have to do is put light diffuser on top of that vermiculite and put the eggs on it. The two with mold may be a loss, but you can certainly try some antifungal powder, it's not going to make them any worse, but it may not save them either. I did the same thing the first year, but I ended up losing the eggs that grew mold. You'll know if you are losing them if the veins start disintegrating.
Last edited by SlitherinSisters; 03-25-2013 at 11:37 PM.
-
-
BPnet Veteran
I know it does look like they are too wet. The humidity is at 80%. There is no condensation whatsoever. The eggs are half buried in the substrate, and they have no wet spots underneath, either. Again, if you look at the first picture, the spots have been there since they were laid.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|