Probe Rearding Problem

[martin82531]

Is Hot Glue ok to glue to probe to the UTH. Also my temps seem to fix themselves when I out my heat lamp on my cold side. Does it really matter what side the heat lamp goes on?

I would't use hot glue as the only adhesive to keep a probe in place, so much can go bad if it falls off. I would use foil tape. I'm currently using flexwat but I was previously using Zoo Med UTH's, during that time I was using the below duck tape to adhere it to a glass enclosure, I was very generous when applying it, never once had an issue, the temp rating for duck tape is 120 degrees.

http://www.reptilebasics.com/aluminum-foil-tape

http://www.homedepot.com/webapp/wcs/...x#.UL_JTYPonng