You have the basic idea... the UTH plugs into the thermostat, and you set the thermostat to the desired temperature. The thermostat has a temperature probe that you will attach to the UTH (So it is sandwiched in-between the underside of the tank and the UTH. I like to use hot glue for this) This measures the temperature of the UTH NOT the temperature inside the tank. You will need a probed thermometer like the one pictured below to tell you the temperature of the cage. Based on the thermometer reading you will set your thermostat. I would start by setting it to 90 degrees and go from there (you have to wait 30 minutes to an hour in-between thermostat adjustments... it takes some time for the UTH to respond)
Check out this thread for more information...
http://ball-pythons.net/forums/showt...04#post1845904









Reply With Quote