ok, here are some terrible pictures!

Here's the stack of 3 cages, you can see the series wire connections between them, taped to the front. The power wire goes out the side of the top cage through the hole that the original light used. I did have to open the hole a little bit with a drill to fit the new cord.


Here is the old light housing, retrofitted with LEDs. I simply routed the wire out of the housing between the snap-on cover and the housing. It's flexible enough to allow the wire and still snap securely together.
This first pic shows the power cord coming in from the side, secured with the clips that came with the original lighting

And the second pic shows one of the series lights with the wire routed out the front of the cage to go to the next one.


Heres the original light housing with the cover off, showing the LED strip I screwed in place. The LED strips have holes at either end for this purpose, and the screws are included. I just screwed them right into the plastic light housing with no problem.
Once with flash and once without, neither pic is that good sorry!



Cords taped to the front where the series cables are routed due to their shortness. I would have preferred to route all the cables out the sides of the cages like the original lighting was, but for now this is it. I may buy longer cables later on if I get sick of the tape.


hope that helps.