Sounds like you went a little overboard, but better safe than sorry I guess. All you needed to do was remove all the stuff from the enclosure clean it, put in new substrate and spray the substrate, then let it air out and dry, then put everything back in. You dont want to breath in PAM, it is a carcinogen. What I would do next time is take the amount of substrate you want in your enclosure, put in in a tub, take it outside, spray it, let it dry and air out for a half an hour, then bring it back inside and put in the enclosure. It should be fine at this point. Also it says on the directions not to spray directly onto the enclosure itself but onto a substrate, if sprayed onto the enclosure it leaves an oily residue and takes longer to dry. PAM works wonders just use it sparingly and correctly.Good Luck to you.
Reply With Quote