Ok so I just removed the eggs from the tub and 4 of them have the same "molding" on them, but not as bad as the roll out. I picked up some of the vermiculite and knew right away it was way too wet. I ended up removing half of the substraint and adding dry, then mixing together to get a good consistency. I also put a piece of light diffuser material directly on top of the vermiculite to allow slight airflow on the bottom of the eggs. I really hope they make it. I'm totally bummed out right now... I knew I should have trusted my instincts and not my hydrometer before I added more water.

Is there anything else at this point that I can do to improve my chances of helping these little guys to full term?

Thanks for the help!