I do have one that is hanging on a bolt that is stuck through an air hole and secured with 2 nuts and washers, but that particular one is mounted by using 2 strips of Scotch brand velcro. I believe it is 1 inch wide. I just cut 2 strips about the same width as the Acu-Rite. I put one across the top and the other near the bottom just above the battery compartment. Something I do now is right at the bottom of the Acu-Rite, I melt a hole just big enough for the probe to fit through and I also put one one the other end. That way I can run the probe out, around, and back in the tub on the other end, so all of the excess probe wire is outside of the tub and not bunched up under the substrate...Originally Posted by alittleFREE
Reply With Quote