Hi,

Where about is the base unit of the acurite?

Is it at ground level on the cool end?

By the way I usually ended up putting the heat lamps on dimmers if needed as well - just to save desperately swapping bulb sizes to try and find the right one.

While I remember;

Once the temp is holding steady in the warm end hide you can move the probe into the cool end hide to see how it is holding as well.

I don't usually pick a spot to permanently place the acurite probe until I have checked all over the place above and below the substrate.

Once I know that everything is dialed in I simply only want it to monitor for changes - generally I end up picking inside the hot end hide.


dr del