Setting up for First BP

[Seak]

Thank you for your replies. I will be setting it up to see where the temp is at. And I think it actually might be a little higher than what I posted, but i'll see. The lids do lock shut, but I think I might grab some straps as a precaution.

So, the uth shouldn't be touching the enclosure? Ohh, maybe I was thinking of a soldering gun. Haha a few minutes after posting this, I found two very good breeders in my area with some really nice ball pythons for great prices.
Thanks again

The UTH sticks to the enclosure, it should be raised off of whatever you have the enclosure on. There needs to be room for the heat from the bottom to escape.