Anyone Used This Product?

[Darkice]

I use the vision racks and i use the BAH1000 with the heat rope also from big apple. The thermostat turns off and on allot but the temps inside the tubs dont fluctuate more then a degree or 2. I have several of them and they work perfect. Im about to buy a couple more for a giant hatchling rack im building.

[rabernet]

Thanks alot for your help, Anyone know exactly the spot or is tbowman right?

Daniel

On a 5 tub rack, mine is taped (with aluminum tape) to the flexwatt on the 3rd (middle) tub slot.

I don't think it's a bad thermostat and it's not unreliable IMO. I have one, I haven't used it yet. I did have the older model. I've since upgraded to a herpstat for that snake.

You haven't used it yet, but you consider it reliable?

[Simpson Balls]

You haven't used it yet, but you consider it reliable?

Haha!

Daniel

[Simpson Balls]

So where do you put the little black thingy?

Daniel

[tbowman]

If you would read I stated that I had the older model of that. It is basically the same thing.

[tbowman]

I Used the older (black) one for 2 years with my Burm. And I ordered the one in the link for my future boa. It has also been recommended by users on RTB.net, and there are a lot of very experienced people on that forum.

[mechnut450]

the black thing is the temp probe I place mine on the heat source and tape it down then I set my johnsons control to allow for about a 93 turn on and shuts off at about 106 I done the temp checks and it give the bps a minium warm spot of about 93. I am planning on taping it in the middle of the tubs ( to prevent the rubbing effec I am seeing) and cut a busted tub up enought to figure out a inside temp with inbedding in the plastic so I can get a more true reading all the time. wit hmy flexwatt glued to the wood it heats the wood up and reflects it around into he tubs..

[Simpson Balls]

the black thing is the temp probe I place mine on the heat source and tape it down then I set my johnsons control to allow for about a 93 turn on and shuts off at about 106 I done the temp checks and it give the bps a minium warm spot of about 93. I am planning on taping it in the middle of the tubs ( to prevent the rubbing effec I am seeing) and cut a busted tub up enought to figure out a inside temp with inbedding in the plastic so I can get a more true reading all the time. wit hmy flexwatt glued to the wood it heats the wood up and reflects it around into he tubs..

Not to be a pain but could you give pics?

Daniel

[SGExotics]

I would say go with something better.. Just invest the extra money into a ranco, johnson, helix, or herpstat.. It will pay off in the long run... Also, your racks going to be 5' long? Not a good idea... That thing is going to sag soooo bad! With racks, its always better to go with tall and skinner than shorter and wider...
~Brandon

[Simpson Balls]

I would say go with something better.. Just invest the extra money into a ranco, johnson, helix, or herpstat.. It will pay off in the long run... Also, your racks going to be 5' long? Not a good idea... That thing is going to sag soooo bad! With racks, its always better to go with tall and skinner than shorter and wider...
~Brandon

Thanks for the help and yea I'll rethink the rack thing. What do you use for a t-stat and also how do you make your banners/sigs?

Daniel