Quote Originally Posted by rocky88 View Post
So correct me if I am wrong but in order to get the best results from your

clutch, the heat needs to be at 88.5 give or take a degree. And the humidity

needs to be about as high as it can be kept right?
Correct

Quote Originally Posted by rocky88 View Post
And with the heat( 88.5) is

that the temp that should be read in the actual clutch tub or just inside the

bator.
Inside the incubator, see below.

Quote Originally Posted by rocky88 View Post
Also do you put your thermostat probe on the inside of the actual

clutch tub and monitor/change the heat/hum. from in there or is all

monitored/changed from just the bator?
Inside the incubator. There was a post a couple months or so ago about how the temperature fluctuates too much in the tub, and that if the incubator temp is spot on, the inside of the tub will be fine.

Quote Originally Posted by rocky88 View Post
If that all made since please help. I

possibly have a clutch on the way very soon.
Good luck!