My options are No heat,Black tape,shipping tape, and scotch tape.Going to a store is not something i get to do everyday so i must order this aluminum tape online
Uh...I guess just secure the corners of it down lightly so you can pull it back up when you get the aluminum tape in. Any tape will do for this purpose.
Make sure that the probe from the thermostat is secure against your flexwatt. If your flexwatt came loose it wouldn't be a big deal but if your probe gets dislodged then you can run into major problems.
~*Rich
1.0 100% Het Albino
1.3 Normal
1.0 Spider
0.1 Mojave
1.0 Pastel 100% Het Goldfinger
0.1 Pastel 66% Het Goldfinger
0.1 Pastel PH Goldfinger
I dont think there is any reason to start a new thread for this question i have so i will not.My problem is that I set my thermostat to 95.Came back and thermostat said 94.I looked at my thermometer and it said 102.6
I set it to 92 hoping that would work better and am now at 76.8.It comes on for about 10-20 sec then shuts off and comes on in about 2-4 min.Is the metal probe retaining heat?.Also the thermometer is in the bottom of the of the 31qt tub with about 1/2 inch of aspen on top.The Thermostat is a Johnson A419 and there is a metal piece on the probes end.Also it is 8 watt 4" flexwatt.