Hi all, ArticBlue (my and my wife's roommate) and I picked up 20 corn snakes between the daytona and Raleigh reptiles shows. We figured with this many we needed a rack so we set out to build one and I took pictures along the way. Here's pictures and explanations of everything, hope this helps some others out there.

Supplies:
4 boards that are 30 inches tall by 3.5 inches wide.
6 boards that are 36 inches tall by 14 inches wide.
The backboard is 30 inches tall by 36 inches wide. (i forgot what the backboard was called but it's near the pegboard and it's like 3/16ths thick if I'm not mistaken)
Screws
Hammer
Staplegun
Stapels

Here's a picture of all of the supplies but the staple gun and staples.


We drilled the 4 side pieces onto the bottom plank and stood it upright.


Place the tubs you're going to use, in our case 6 quart sterilite tubs, on the bottom plank like so.


Place the next board on top of the tubs and then drill in through the side planks.


Repeat the last two steps. Soon you'll be halfway done!



Continue until you place the last plank on the top, then move around to the back and use the staple gun to staple the thin backboard onto the rack.


Here's the rack all set up with tubs and snakes inside.


We don't have the flexwatt or thermostat yet but they're on the way. Also if you notice the backboard is just a tad bit shorter than the actual rack, that was because I didn't care to cut wholes for the cords from the flexwat, you can add the extra inch or two and cut holes for the wires if you like, I just didn't care to do so. We are going to take the tubs out soon and stain/finish it, as well as sand down the corners but I figured I'd go ahead and post. It cost us about 50 bucks all together to build this (take into account we already had the hammer, staples, and staple gun)

Hope this helps someone else!