I have to admit that I am almost at my wits end with the d@mn thing. Not only were the instructions written backwards and in Greek (figuratively, not literally) but the thing is barely functional. The sensor literally takes HOURS to sense an increase in temperature. Currently sitting directly under the CHE, where it has been for 7 FREAKING HOURS it still says that it's only 85 degrees. The Accurite sensor, sitting 1 inch from it, is registering at 90, and has been for 6 hours and 45 minutes. It has Slowly inched up from where it was originally showing 74 degrees (this was the reading after doing a full clean/substrate change today), and it has taken this long for it to get up to 85 degrees, when it is actually closer to 90-91 degrees in there. It's MADDENING. There is no reason for it to take so long to true up the temperature! And now I am worried that if there ever is a temp spike, it will take the thermostat 8 blessed hours to realize it and turn off the CHE.

Does anyone else use this brand and/or have this issue? I am on the verge of returning the stupid thing and just ordering some jumpstarts.