Hey guy, I wanted to bring up a point and see what everyone elses thoughts on the Issue.

I'm in a glass enclosure, until my AP arrives, and I have a UTH as well as a lamp set up, each on its own channel in the Herpstat 2.
This is how it's ordered from bottom to top (see pictures)
1: UTH
2: Channel 1 prob
3: Glass
4: Substrate 1/8" to 1/4" thick
5: Hide
6: Channel 2 Prob sitting on top of the Hide
7: Accurite temp stuck on the back glass half way up
8: Lid with Lamp on top and Foil on it to hold in heat.

Channel one (UTH) is set to 93 degrees while it holds the temperature on the prob perfectly, when I shoot the substrate it read 83-85 when I move the substrate and shoot the glass directly it only reads 85-87. I wanted to get a feedback from people that have ran into this issue and see their solution. I'm assuming the air gap caused from the prob and the glass itself are causing the heat to disperse and lower, I however don't want to just start ramping up temps and take a chance on causing a burn, without making 110% sure that is the next step to take.



[URL=http://s300.photobucket.com/user/CoryHEO/media/Mobile%20Uploads/image_zpsrrpijtgz.jpg.html][/URL





P.s. on a side note, this is my new Buddy, I have to get it sexed still but any thoughts on names?
he's a super friendly pinstripe that loves to be handled!