Hey err'one,

I am attempting to buy some Flex Watt heat tape, but I'm a little confused...
I know it's possible to wire up several segments in parallel: http://www.beanfarm.com/heating/Flexwatt_parallel.pdf

However, I have a question... can this be done using only the 6-foot electrical cord supplied with the tape? By this I mean, once I separate the two sides of the wire (joined by plastic), can I remove the plastic coating from the end, join that up to the first bit of Flex Watt. Then take off some plastic from the middle of the cord and wire that up to the second strip of Flex Watt?
Sorry if this is confusing, but if you look at the pdf above I think you'll understand what I'm getting at.
Thanks in advance!