Quote Originally Posted by yeroc1982 View Post
Ok thx. The tub size are 25q, 19x15x7 inches tall. Will be using cocofiber as substrate. I will place the tstat probe under one of the tubs, so it's between flexwatt and tub. Should I tape the flexwatt so I can get it nice and close to the bottom if the tub or will it be ok laying flat? Cuz like I said the tuba aren't perfectly flush flat on the bottom. They kinda go in on the middle
You will want to tape the flexwatt down with some aluminium tape. Just run some of the tape along the long edges(just enough to hold it down), do not cover the whole thing. You can get this tape in most hardware stores. I found some at Walmart cheaper. Then tape your prob on the flexwatt next to the tub. Give it ample time to warm up, then check the inside temp on the bottom of the tub under the substrate. Cause this is where you snake will be most of the time, and snake will move the substrate. Hope this helps!