I posted yesterday about this, but it's still not goin right... I wired 3- 11" pieces of flexwatt all have thier own cord. The first one I finished I plugged in and tested it on a reostat ( I know get a thermostat they are better... I dont have the cash for that right now.) It went to 103F and then I lowered it to about 97F and left the reostat set at that.. I then went on to wire the last 2 pieces, and test them. I tested one at a time and both of them would not go past 89F... SO I am trying again I have 2 hooked to the reostat and one is plugged into the outlet, with a probe taped to the center... NONE of them are goin above 90F..

I'm new to using the soldering iron but I tried on some scrap first... I melted the plastic from the flexwatt like I've seen done in the DIY's .. but like I said I'm new to the solder iron. and the plastic on the other side melted a lil..

Did I fubar my flexwatt? I Tinned both the wire and flexwatt.. PLEASE HELP.. Not sure if I can undo it and re try on the flexwatt, or am I S.O.L?

Thank you in advance and for reading all this, there were a few more choice words I could have used to tell you how I feel, but I dont wanna get another warning. Thanks again

Cheers