Hey guys,,
I just emailed Dion about this herpstat problem, but I thought I would post this here too just in case anyone else has ever experienced this before and maybe had some tips.

So we have a Herpstat II which is attached to an incubator running 200 watts on one output (10 feet total of 11 inch heat tape).
When I try hooking it up to output 1, the alarm continuously goes off. Previously the high and low alarm was set for 1.5 degrees and I had disabled it, but now it just continues to go off.
When I try to hook it up to output 2, the temperature is set to 89.0, and when I check the high/lows in the morning, for the past 2 days it has dropped down to 74 degrees, with no night drop or anything like that set up. It seems to just drop to this temperature at some point, and then eventually go back up.
By the way, this is just a dry run, no eggs in the bator yet, but hopefully this gets settled before that comes

I've never had any problems with this with our other herpstats, and this one hasn't done anything like this before.

Appreciate the feedback