Sometime last week I went into my room to check on the temps in my Ball python enclosures and they were outrageously high. In the bottom tub, temps reached up to 112F, and in the top tub the temps reached up to 124F (both are 10g-20g UTHs and heat is measured with a digital thermometer with probe). I knew that the probe popped off because of the aluminum tape I use and this isn't the first time this has happened. I quickly took my Ball pythons out of their enclosures and held them for a while so they could cool off; their bellies were pretty warm. I have the probe taped with aluminum tape onto the bottom tub's UTH. The aluminum tape is pretty sticky, but after a bit it just comes right off the UTH. What should I do so this doesn't happen again?