Does this look right??

[edie]

I only said to use a probe bc its difficult to measure when you use ta temp gun when the tub is pushed all the way in. lol

I have a temp gun and a temp/humidity gauge with a probe

All of a sudden I'm having a hard time with the Helix/flexwatt now though.. The Helix says 90.. when I temp gun the actual flexwatt it says 110.. and the temp/humidity gauge probe says 113.. I don't really know what to do.. I'm paranoid that I'm going to burn the house down if I'm not doing something right

[Krazy99CL]

Just make sure you have the helix probe taped on the flexwatt and set it at 90. put the temp probe on inside on the tub and measure the temp. Bump the helix up to where it would read 90 on the temp gauge.

You should be fine.

Just to let you know, the temp on the bottom of the rack is going to always be a few degrees lower.

[Krazy99CL]

Another suggestion I would do is raise the rack higher off the floor. Good luck.

[edie]

Thanks! I actually just got everything figured out after I posted that my temps were going crazy.. the probe had moved and thats why everything was getting weird.. the temps have been stable all day now

[Krazy99CL]

Thanks! I actually just got everything figured out after I posted that my temps were going crazy.. the probe had moved and thats why everything was getting weird.. the temps have been stable all day now

hahah. Thats great to hear. hope it works out for you. Keep herping!

[herpmajor]

Looks awsome!