accu-rite

[Noek]

I currently have a johnson control thermostat that reads the temp at the UTH (92), so that's covered.

I also have a flukers digital thermometer/hydrometer that sits on the side wall in the middle (usually meters about 75 degrees) where it sits. The cold side of the enclosure measures 81 degrees at the bottom.

Maybe I'm splitting hairs??

[Argentra]

The t-stat sets the temp of the UTH, that doesn't mean that the temp where the snake is is the same. Hence placing the probe for 'outdoor' reading there.

The flukers t-meter is ok, but it can only tell you the ambient air temp, and placing it up high doesn't do much good when the snake is on the floor.

Also, what are you using to measure the temp of the cool side?

[Noek]

There is a flukers at the bottom of the cold side and one in the middle between the cold and warm side that sits up halfway on the enclosure and the t-stat monitoring the warm side

so basically the acu-rite would be replacing the two that I currently have and probably be more accurate, which is what I'm looking to do

[Argentra]

Basically, yes. It would be quite a bit more accurate since the probe would be exactly where you want to read temps. The only thing better would be a temp gun.

Just make sure not to get the unit wet...they stop working then.

[Noek]

thanks for the great info

I get paranoid about the temp and humidity so I'm constantly looking for better ways to improve

thanks again

[beardieguy]

i bought the same accurite thermo combo at lowes.they had it in their garden section

[Argentra]

NP, that's what I'm here for