Herpstat 2 question

[Rvnhawk]

So I bought a Herpstat 2 Redline. Set it up yesterday and it was running fine - temps were steady where I set them when I went to bed. It ran for probably 8 hours before I went to bed. I checked it once sometime over night, still good.

I had a Zoomed UTH set up on one output, an infrared bulb set up on another output. Both were set on dimming.

I got up this morning with the display reading “Error detected - 120v A.C. signal”.

I can’t find anything anywhere that tells me what this means. Anyone know?


Sent from my iPhone using Tapatalk

[RickyNY]

It means your sensor probe and 120 ac wire are too close together. Separate them.

edit: Sensor probe wire, not the sensor tip.

[Rvnhawk]

Ok, how do I get the error message to reset? (I’m not at home right now, so if that’s a simple answer, forgive me).


Sent from my iPhone using Tapatalk

[larryd23]

Sorry... I don't have time to look it up, but here's the manual: https://www.spyderrobotics.com/index...products_id=33

[CALM Pythons]

It means your sensor probe and 120 ac wire are too close together. Separate them.

edit: Sensor probe wire, not the sensor tip.

Wow. Never thought of that. All mine run with the RHP wire and into a hole in the back of my AP’s. Guess ive always been lucky?


Sent from my iPhone using Tapatalk