» Site Navigation
0 members and 1,393 guests
No Members online
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.
» Today's Birthdays
» Stats
Members: 75,917
Threads: 249,118
Posts: 2,572,202
Top Poster: JLC (31,651)
Welcome to our newest member, Necbov
|
-
Registered User
General heating concern
Me again! My tank has been a little undesirable with hot temps lately. The thermometer I have settled on the substrate under the lights and above the UTH say it's 86-87 on the hot side floor. My BP will sit on a piece of wood up against a (carpet covered) UTH on the side or sit under the 60w day or 75w night light either draped in a basking location or perched on a plant on the wall if he's really feeling the chill. I haven't seen him using the warm hide much lately though, he's taken to staying in the cool (75 degree range), dark hide nearly all day and moving later if he wants. The setup is shown here:

(Sloppy as crap right???) The towels get draped over the front 24/7 for security and insulation. Any ideas on getting those extra few degrees? I have been thinking about switching to a CHE on a dimmer in hopes it'll raise temps enough I can remove the side UTH, maybe leave out the lighting altogether.
-
-
Re: General heating concern
Whoa... that is um, cluttered.. if you remove some of that stuff you might get some more warmth where your snake needs it. (On the ground).. and purchase an IR gun.
Sent from my iPhone using Tapatalk
0.1 Mojave
1.0 Butter
1.0 Pastel Enchi
0.1 Bumblebee
0.1 Orange Dream Yellowbelly
0.1 Leopard
0.1 Firefly
1.0 Hypo Brooks King
1.0 Kenyan Sand Boa
-
-
You really do need a IR temp gun to know what the surface temps really are. Probed thermometers are not great for that.
The uth on the side is not doing much for your snake. You have been told what to do with it and choosing not to is leaving you with the same poor results.
Get a tstat and set it up correctly.
KMG 
0.1 BP 1.1 Blood Python 1.0 Brazilian Rainbow Boa 1.0 Aru Green Tree Python
0.1 Emerald Tree Boa 0.1 Dumeril Boa 0.1 Carpet Python 0.1 Central American Boa
0.1 Brooks Kingsnake 0.1 Speckled Kingsnake 1.0 Western Hognose
0.1 Blonde Madagascar Hognose 1.0 Columbian Boa
1.1 Olde English Bulldogge 1.0 Pit Bull

-
The Following User Says Thank You to KMG For This Useful Post:
Mangiapane85 (11-24-2016)
-
Registered User
I'll remove the side heater (I must've missed the demand to take it off before when I was figuring out what he would eat) then and try to clear some stuff back out. The thermostat is on the UTH on the bottom and is set to 89, I know it could go lower. I can also order a IR temp gun, I should get my paycheck in a day or sooner. Any preference to the CHE to the heat lamps?
-
The Following User Says Thank You to ferrislongdog For This Useful Post:
-
Re: General heating concern
As regards all the 'clutter' ...... Royals do welcome all the undergrowth and hiding places so I'm actually fine with that layout . Obviously the heat issue needs to be sorted out and a 12 dollar digital temperature gun off eBay is a must !!
Sent from my iPad using Tapatalk
-
The Following 2 Users Say Thank You to Zincubus For This Useful Post:
Albert Clark (11-25-2016),KMG (11-24-2016)
-
Re: General heating concern
 Originally Posted by Zincubus
As regards all the 'clutter' ...... Royals do welcome all the undergrowth and hiding places so I'm actually fine with that layout . Obviously the heat issue needs to be sorted out and a 12 dollar digital temperature gun off eBay is a must !!
Sent from my iPad using Tapatalk
Dude. That's just more than a ball python needs. I know you're all about a "naturalistic" setup, but there's nothing natural about that. It can't even spread out across the tank because of all that stuff.
Sent from my iPhone using Tapatalk
0.1 Mojave
1.0 Butter
1.0 Pastel Enchi
0.1 Bumblebee
0.1 Orange Dream Yellowbelly
0.1 Leopard
0.1 Firefly
1.0 Hypo Brooks King
1.0 Kenyan Sand Boa
-
-
General heating concern
 Originally Posted by Mangiapane85
Dude. That's just more than a ball python needs. I know you're all about a "naturalistic" setup, but there's nothing natural about that. It can't even spread out across the tank because of all that stuff.
Sent from my iPhone using Tapatalk
I'm not sure .... It would simply slither all over / under and around it surely . Everyone keeps telling people that Royals like confined spaces and hate open spaces ...
It's just the sheet over the top that spoils it for me
Last edited by Zincubus; 11-24-2016 at 09:27 PM.
-
-
Registered User
Re: General heating concern
 Originally Posted by Mangiapane85
Dude. That's just more than a ball python needs. I know you're all about a "naturalistic" setup, but there's nothing natural about that. It can't even spread out across the tank because of all that stuff.
Sent from my iPhone using Tapatalk
He's still smaller hence the foliage so he doesn't feel exposed coming out to change sides or get some water. He still is able to spread out when he chooses to, and I'll be removing things as he gets bigger so he has space. When he's out at night when it's far enough from pre or post feeding, I let him explore via my bed or the floor supervised for some quick extra exercise and movement. The ivy really makes it look much worse than it is too.
The towels look awful covering the whole front of the tank, lol but they have to stay to help contain the heat I need to keep better and the humidity, as well as security so he doesn't feel as out there.
-
The Following User Says Thank You to ferrislongdog For This Useful Post:
Albert Clark (11-25-2016)
-
More cover is usually better than too little.
If the snake wants to spread out it can.
My BP has always had plenty of cover and has no problem stretching out.
KMG 
0.1 BP 1.1 Blood Python 1.0 Brazilian Rainbow Boa 1.0 Aru Green Tree Python
0.1 Emerald Tree Boa 0.1 Dumeril Boa 0.1 Carpet Python 0.1 Central American Boa
0.1 Brooks Kingsnake 0.1 Speckled Kingsnake 1.0 Western Hognose
0.1 Blonde Madagascar Hognose 1.0 Columbian Boa
1.1 Olde English Bulldogge 1.0 Pit Bull

-
-
If you don't have an IR temperature gun yet, this one is marked down to $16 from $70 for Black Friday:
https://www.amazon.com/dp/B013X0NQT0..._BB5nybAHA5BZ4
-
The Following 4 Users Say Thank You to bcr229 For This Useful Post:
Albert Clark (11-25-2016),ferrislongdog (11-24-2016),KMG (11-24-2016),Neal (11-25-2016)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|