» Site Navigation
3 members and 867 guests
Most users ever online was 47,180, 07-16-2025 at 05:30 PM.
» Today's Birthdays
» Stats
Members: 75,905
Threads: 249,101
Posts: 2,572,082
Top Poster: JLC (31,651)
|
-
Thermostat probe?
Where are you supposed to put the thermostat probe in a rack? My probe keeps moving out of place.
-
-
Re: Thermostat probe?
Tape it down flat in direct contact with the tape on one of the middle shelves.
-
The Following 2 Users Say Thank You to Eric Alan For This Useful Post:
Albert Clark (08-11-2016),Megg (08-12-2016)
-
Re: Thermostat probe?
 Originally Posted by Eric Alan
Tape it down flat in direct contact with the tape on one of the middle shelves.
That's what I've been trying, but everytime I pull a tub out it gets moved.
Sent from my HTC One M9 using Tapatalk
-
-
I run my tape wider than the tubs and then place the probe to one side, so the tub doesn't hit it when slid into or out of the rack.
-
The Following User Says Thank You to bcr229 For This Useful Post:
-
Re: Thermostat probe?
Is the heat tape belly heat or back heat? The main thing is to tape the probe wire and don't cover the probe itself with the tape. You will need a wide strip of tape to keep it secured. Sounds like your heat tape is anchored as belly heat.
Last edited by Albert Clark; 08-11-2016 at 06:10 PM.
 Stay in peace and not pieces.
-
-
Re: Thermostat probe?
Originally Posted by Albert Clark
Is the heat tape belly heat or back heat? The main thing is to tape the probe wire and don't cover the probe itself with the tape. You will need a wide strip of tape to keep it secured. Sounds like your heat tape is anchored as belly heat.
Yes, it is belly heat. I have one of the AP combo racks that holds 15 or 32 qt tubs, but I've got all 32 qt tubs in there right now.
Last edited by Megg; 08-12-2016 at 09:49 PM.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Reply With Quote
