Is this tub setup OK?

[Klogue1]

I did read Vyprz tub tutorial on how to setup a proper one, but just wanted to make sure it's not too small I saw that a lot of breeders and people who use tubs don't usually provide a cool side hide, and mine wouldn't fit, so I didn't put it in. But please let me know if you think I should switch out the water bowl for a smaller one and place a cool hide in!
The quality is terrible, my phone and my camera hate me



Do you guys also think there are enough air holes? I soldered some holes into the front of the tub only:

[drama x]

Looks good! I drill holes ALL the way around my tubs and even cut out the tops and place screens for even air flow.

[Klogue1]

16 quarts, by the way

[Klogue1]

Oh, ok Drama, thanks!

[satomi325]

Looks fine to me. Maybe solder a few holes on the side?


If the humidity is too high, then you can switch out the water bowl to a smaller one or add more air holes.

[Klogue1]

Thank you satomi! I am soldering some more as soon as the iron warms up

[The Serpent Merchant]

What are you using to heat it?

[Klogue1]

I'm using a UTH on a thermostat.

[Royal Hijinx]

Looks good. I put some holes in the lid as well for air flow.

[The Serpent Merchant]

I'm using a UTH on a thermostat.

Ok, looks good though I would make the substrate layer a little thinner.