» Site Navigation
2 members and 3,358 guests
Most users ever online was 6,337, 01-24-2020 at 04:30 AM.
» Today's Birthdays
» Stats
Members: 75,097
Threads: 248,541
Posts: 2,568,754
Top Poster: JLC (31,651)
|
-
Registered User
any suggestions on raising the cool side temp?
my cool side temp stays at a temp of 78.6-79.9 degrees is there any other way to get it to the mid 80's (82-84) without using heatlamps and whatnot?? my warm side gets to 94.6 sometimes up to 95. im also using a 20 gal tank with an ultratherm heatpad purchased from rich at reptile basics.
any and all suggestions are welcome and i thank you in advance.
-
-
Registered User
Re: any suggestions on raising the cool side temp?
I usually have a towel or a small blanket draped over my cool side to help boost its ambient temps.
-
-
Registered User
Re: any suggestions on raising the cool side temp?
yea i have the uhm foil paper and duct tape tactic going on but still cant seem to get the temps to even out
-
-
BPnet Veteran
Re: any suggestions on raising the cool side temp?
you can heat the room you are keeping the snakes in....
a small space heater on a ranco/johnson control will keep the room temps up which in turn will raise the cool side temps.
-
-
Registered User
Re: any suggestions on raising the cool side temp?
are there any other suggestions..'cause my coolside temps drop dramatically at night..they get low as 76. im using a ultratherm heatpad from rich at reptile basics with a 20 gallon tank.. on newspaper as substrate
-
-
Re: any suggestions on raising the cool side temp?
Try a ceramic heat emitter (100 watt)on a thermostat over the cool side,out side of tank, they can cause severe burns if touched. Glass Tanks are harder control, I would switch to a tub. Or another UTH on thermostat on cool side.
-
-
Registered User
Re: any suggestions on raising the cool side temp?
Originally Posted by westcoastjungle
Try a ceramic heat emitter (100 watt)on a thermostat over the cool side,out side of tank, they can cause severe burns if touched. Glass Tanks are harder control, I would switch to a tub. Or another UTH on thermostat on cool side.
would a 75watt infrared heat bulb do it? and if so what side would i setup the bulb? on the warm side and let the heat flow to the cool side..or set up the bulb over the cool side? therefore having to warm sides huh..lol
-
-
Registered User
Re: any suggestions on raising the cool side temp?
Originally Posted by SGB_74
would a 75watt infrared heat bulb do it? and if so what side would i setup the bulb? on the warm side and let the heat flow to the cool side..or set up the bulb over the cool side? therefore having to warm sides huh..lol
Use the bulb on either a proportional thermostat or a rheostat over the cool side, then adjust your heat pad again to maintain proper warm side temps.
-
-
Re: any suggestions on raising the cool side temp?
Originally Posted by SGB_74
my cool side temp stays at a temp of 78.6-79.9 degrees is there any other way to get it to the mid 80's (82-84) without using heatlamps and whatnot?? my warm side gets to 94.6 sometimes up to 95. im also using a 20 gal tank with an ultratherm heatpad purchased from rich at reptile basics.
any and all suggestions are welcome and i thank you in advance.
Your temps are fine. I would not worry about changing anything.
-
-
Registered User
Re: any suggestions on raising the cool side temp?
from my understanding anything that got down in the low 70's could turn out to be harmful for the snake
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|