hey guys i haven’t posted on here in a while but i had a question about getting the temps right in an animal plastics T8 enclosure. i recently moved my bp into this enclosure after having him in a tub for a year and am having difficulty getting the temps right. i am heating the enclosure with a pro products heat panel connected to a thermostat with the temperature probe situated on the hot side about halfway down the back, right now i have the thermostat set to 85 but i’m not sure if that’s the best temp to have it at. i had taken a day or so before i put my bp in to try to get the temps right and i thought i had it down but apparently not. they seem to fluctuate quite a lot, sometimes the cool side will be where i want it (~78) and then sometimes it will drop down a lot (~73). and the surface temp on the hot side will usually be where i want it (88-90) but the inside of the hot side hide will be low 80’s. is this normal? i guess i am just wondering what temps are the most important, i’m guessing floor surface temps but i would love any advice. i’ve been using a heat pad and che before this and i had my temps dialed in so in just having a little trouble with this new setup. any advice is very appreciated.