I have a 5-tier hollow core PVC rack that utilizes heatcord woven through the hollow areas inside the right side of the rack. (The bins go in short, not deep.) What I want to do (if it’s going to work) is run a single length of flexwatt along each shelf. In order to do this, I’d need to cut a slot on each side of the shelves to thread the heat tape through.
1. Will this work?
2. What tool does my cousin need to cut these slots? (He has tools, electric ones! Lol)
3. Would aluminum tape be a good way to secure the flexwatt? Other recommendations?