I'm making two rubbermaid homes tomorrow, thanks for sharing...
I think I'm gonna cut out a big rectangle for the uvb fixture, then cut a piece of wire mesh a bit bigger. Then hold the mesh over the fire in our wood stove till it's red. When dropped on it'll melt itself into the plastic perfectly! Total cost- 15$
how funny...my bro ripped the screen on one of my lids, so i cut some plastic the size of the holes and held a lighter(lit.,.haha) under the...worked like a charm. if you hold the light right up next to the plastic it wont turn brown. but it would deffintaly warp. so just in case your idea doesnt work (i doubt it wouldnt) you could do that.
"I think it might be helpful for everyone to remember that the purpose of a forum like this is to EXCHANGE IDEAS, not dictate what is right or wrong or good or bad. If you disagree with what someone else is suggesting, you can say so without being argumentative or completely slamming the guy (or girl)." - Smynx
Well, the rubbermaid is made of some heavy duty stuff that doesn't melt easily.... So I drilled holes and used those little twisty things you get on loafs of bread to hold the screen down. Real nift. My anoles are in paradise...