Temps

[trollock]

Ok, i got the UTH and a thermostat earlier, got the temp probe undersubstrate in one hide, I have temp set to low and inside hide temp is like 100, Is that ok???? Outside temp in the 90's

[Boanerges]

No 100 is waaaay to high. How are you measuring your temps?

[trollock]

temp gauge witha prob. I am using paper towels, have the mat on bottem of plastic tub, with duck tape, then probe taped on inside bottom, then paper towel substrate, then hide on top of that, he laying on top of prob hide.

[trollock]

Wierd temp dont seem that high, seems wrong, using a temp guage from zoo med, i guess i could move probe to see if it reads diff?

[trollock]

Help, plz... temp staying around 100 but cant tell if its because its taped to pad.

[kitedemon]

First 100º is way to high 94 at the most but I'd recommend less than that 92 no higher. The reason is that most cheap thermometers are not very accurate no better that 2 degrees -+ IR guns are about the same unless you spend serious bucks on them. (100+)

Don't place any TAPE INSIDE the enclosure use silicone or hot melt glue (let it cool before returning the snake) Not Tape.

Are you using a 500r thermostat or is it a rheostat one? The 500r should be able to go cooler the rheostat too but it depends on the wattage of the pad. Try this for a quick fix remove the pad from the tub and leave a small air space between the tub and pad that should reduce the temp until you can figure out what is wrong.

I will always recommend a proportional thermostat as the most valuable part of any set up many will argue with me over that but that is my opinion. You can set the temp on one and it will feather the power to the heating unit to maintain the correct temp. It will also handle variations in the space that casual keepers often have. Rheostats won't they require steady room temps to work.

[trollock]

Ok, temp went down into lower 90's once i removed tape, just have prob sitting under substrate for now , Seems to be coming down.

Yes i am using the Rheostats.

[Alexandra V]

Ok, temp went down into lower 90's once i removed tape, just have prob sitting under substrate for now , Seems to be coming down.

Yes i am using the Rheostats.

The tape was probably creating a heat bubble, so all the air got trapped and re-heated, giving you a bad reading.

[trollock]

Yeah, it stabilzed at 96 at low setting which is still too high, gonna try lifting the tank off the pad a bit.

[trollock]

K sry if im being a pain , I got the temp inside the hide to a steady 94 degress, ambient temp at 85 on heat pad side and 81 or soo on other end, Is that a good temp.