- Forum
» Site Navigation
4 members and 3,403 guests
Most users ever online was 6,337, 01-24-2020 at 04:30 AM.
» Today's Birthdays
» Stats
Members: 75,097
Threads: 248,541
Posts: 2,568,756
Top Poster: JLC (31,651)
|
-
RHP never turns off?
I have a 40w RHP in a 4x2x12" enclosure trying to warm up one side a bit. The thermostat is set on 80F but as far as I've seen it never reaches temp to flip off the RHP, yet it doesn't seem to be very warm in the enclosure except the air immediately under the panel. Even the substrate directly beneath it is just lukewarm. Is there something wrong with the panel or is it just not strong enough for a 72F room?
-
Where is the thermostat probe?
-
It's on the back wall centered with the panel a few inches off the substrate, really not that far away from the panel.
-
Re: RHP never turns off?
Quote:
Originally Posted by lisalombs
It's on the back wall centered with the panel a few inches off the substrate, really not that far away from the panel.
The probe should be sandwhiched between the RHP and the enclosure.
-
Re: RHP never turns off?
Quote:
Originally Posted by wnateg
The probe should be sandwhiched between the RHP and the enclosure.
It's perfectly fine hanging along the wall below the panel.
Have you tried taking a temperature reading of the floor directly under the panel using a temp gun or IR/point thermometer?
-
Re: RHP never turns off?
Quote:
Originally Posted by wnateg
The probe should be sandwhiched between the RHP and the enclosure.
Quote:
Originally Posted by bcr229
It's perfectly fine hanging along the wall below the panel.
Have you tried taking a temperature reading of the floor directly under the panel using a temp gun or IR/point thermometer?
Oops, I'm thinking of an UTH. Sorry.
-
Re: RHP never turns off?
Quote:
Originally Posted by wnateg
The probe should be sandwhiched between the RHP and the enclosure.
I think you are thinking of a UTH. :)
-
Re: RHP never turns off?
Quote:
Originally Posted by Bodie
I think you are thinking of a UTH. :)
Sorry wnateg. I did see your response. Thought I had scrolled down the whole thread. Sorry
|