Hydrofarm thermostat ?

Hey guys i have a little problem with my new hydrofarm thermostat if any one could help me the problem is that the thermostat doesnt seem to have an accurate reading i have a temp gun to double check everythin so wat temperture do i need to set the thermostat to have the temperature inside the hotspot at 88-90?

That is going to depend on a lot of things.

Where is the hydrofarms probe?

How far off is the hydrofarm reading?

What substrate are you using, and how thick of a layer?

What size/type cage are you using?

Well, the thermostat will usually read lower/higher than the temp inside the tank because the temp probe for the Hydrofarm is between the glass and the heat pad.

What you'll have to do is adjust the thermostat up or down until the temperature with your heat gun is where you want it to be.

I have my Hydrofarm set at 97, and it keeps my tank hot spot at 90-91

Also, your temp gun may be inconsistent. I am pretty sure the Pro Exotics one i have is.

You may end up setting your thermostat to 95 degrees or more to achieve your desired hot spot temp depending on all the things mentioned above.

The probe is inside the eco earth bedding half an inch under the hide the readin is off by +6 and im usin a 15 qt tub

How thick is the substrate layer overall?

6 degrees different honestly isn't that much off considering the hydrofarm can be reading at least 4 F off and still be working "according to specs" Your temp gun probably has about the same error. That means they could read 6-8 degrees off of each other and still have everything be working properly.

So how will i ever know the real temperature? I dont wana harm my snake

Just do regular temp checks. :)

Your thermostat probe needs to be directly on the heat pad (uth). When I set my first tank up I made the same mistake, your snake can burrow and move the probe causing the thermostat to turn on and overheat your hotspot.

Do i need to take the prove to the bottom of the tub?

Tape* sorry

Never use tape inside a snake cage.

with the substrate you are using your probe is probably ok where it is, but the safest place for the thermostat probe is sandwiched in between the outside bottom of the tub and the UTH itself.

So basically on the bottom of the tub right?

Yup. But underneath, on the bottom.

yea taped to the uth

you got it. :)

Lol thank you :)

Remember you want to temp the surface that your snake can touch, if you are using eco then your snake can burrow to the floor of the tub. You do not want the floor getting over 95ish degrees.