Tubs sitting on heat tape ?

So I built my rack, I see that my tubs rub my heat tape when I pull them out. Is this bad or will it get worse in time. I was thinking about putting electrical tape over the traffic area is this a good idea? I would of found chimes to lift the tub but in doing so my tubs would be very tight. I don't know if I should start over and space it right.

The problem is that wood contract and expend all the time, and if you did not plan for enough space the rubbing will get worse a time.

This can damage the heat tape therefore you need to keep a real close eye on it and replace a needed.

That's why I prefer recessed heat ;)

Well the only thing close to wood is the panel besides that the rack itself is plastic.

Put some of that aluminum tape along the flexwatt where the bins rub. The bin will rub on the aluminum not the flexwatt.

Foil tape?

Quote:

---

Originally Posted by KingPythons

Foil tape?

---

Foil tape is aluminum tape. Its used for ducting and hot temps. You can get it at any hardware store. Better than electrical tape.

Sent from my DROID RAZR using Tapatalk 2

Quote:

---

Originally Posted by KingPythons

Foil tape?

---

http://www.walmart.com/ip/Duck-HVAC-...ndingMethod=rr

If you used expended PVC and it is rubbing and has so from the start it's because you built it a little too tight.

When you build a rack the best is to use the tub as spacer plus something the thickness of a ruler placed on the top, if you only used the tub it is too tight of a fit.

I'm taking the bolts of and spacing it better but will do with the foil tape

I thought about using something like this over the heat tape to protect it from the tub rubbing it.

http://shop.hobbylobby.com/products/...lastic-514158/

The foil tape won't do anything. I tried that and a year later I had to buy all new flexwatt because if you touched the flexwatt you would get shocked pretty good-and the foil tape made it even worse because it wasn't just in the one area that you got shocked, it was the whole dang thing. Find a way to get the shims in there, it should only make it tight in the back. I use composite window shims, not sure if that's what you have, but I really like them and you can cut them down so you are only using the thinner half.

Quote:

---

Originally Posted by SlitherinSisters

The foil tape won't do anything. I tried that and a year later I had to buy all new flexwatt because if you touched the flexwatt you would get shocked pretty good-and the foil tape made it even worse because it wasn't just in the one area that you got shocked, it was the whole dang thing. Find a way to get the shims in there, it should only make it tight in the back. I use composite window shims, not sure if that's what you have, but I really like them and you can cut them down so you are only using the thinner half.

---

It sounds like maybe the connections weren't insulated too good...
I definitely know what a good shocking feels like :)
Side story: I was repairing an outlet in my mom's house and she said "ya, the breaker is off for that room"....IT WAS NOT. First time I ever yelled the f-bomb infront of my mom...haha...

My flexwatt was soldered to the wire, not plastic clamped like in the kit you can buy. I just covered the soldering with liquid electrical tape and let it dry. I LOVE aluminum duct tape, it is super handy and holds like no other! :)