3 clutch Incubator?

Hi everyone,

This is our first season breeding Ball Pythons and we will have 3 females breeding (Spider, Woma, and Normal). I was wondering what type of incubator would be recommended for only 3 clutches this year?

Thanks!

The one you make is always your best bet, and I would recommend something you can grown into.

I use the natures sprit incubator and LOVE it.:gj:

http://nsreptiles.com/incubator.html

Unless you are going to only do a few clutches a year, I recommend building something that will hold alot more than what you can do next year... I only produced 5 clutches this year and @ capacity my incubator will hold about 20 clutches... It is way cheaper to build one as well

I agree with jjmitchell I'm building an incubator now but will build a bigger one when I expand my collection. The cost will only range around 150 if you build. You can get a broken freezer for free and all you need is heat tape, thermostat, and fans.

Thanks for the responses. Does anyone have any links to "How To's" on building an incubator.

Check out the DIY section of the site. There are lots of good posts there.

I would build your own as well. It's super easy.

All you need:
A fridge
Some flexwatt
Computer fan
Old cell phone charger (to wire the computer fan)
Thermostat

Here is a picture of mine, it can hold 12 clutches
http://i157.photobucket.com/albums/t...ding/002-2.jpg

If you do decide to go with a commercial made one - Natures Spirit all the way!

I made my own out of a small broken office refridgerator. We only had two clutches this past year and are expecting 4 this year but our incubator holds 6. And last year our first clutch had hatched before the second was even laid even though both girls were bred the same days!! Was very humerous for us....

Thanks for the advice everyone. We still have some time to decide, were gonna look into building one.