Thermostat and flexwatt heat tape.

Quote:

---

Originally Posted by BrandyL1193

So the herpstat probe is above the RPH? (Between the panel and cage)?

Sent from my SCH-I535 using Tapatalk

---

Exactly. Heres a photo in which I circled the actual probe:

http://img.tapatalk.com/d/14/06/14/da2a6agy.jpg

In regards to the RHP, it's held by two screws that come with it. Yes, the Reptile Basics is a little taller but I prefer them over Pro Heat for personal reasons. Both pannels will work just fine though.

Sent from my SAMSUNG-SGH-I747 using Tapatalk

Sweet! Thanks for all the help!!

Sent from my SCH-I535 using Tapatalk

Quote:

---

Originally Posted by BrandyL1193

Sweet! Thanks for all the help!!

Sent from my SCH-I535 using Tapatalk

---

No worries. Hopefully I didnt confuse you too much.

Here's a really good thread about how to setup a T8 which has a lot of useful information and ideas. Ive been trying to get this stickied for a while now...

http://ball-pythons.net/forums/showthread.php?t=165571


Sent from my SAMSUNG-SGH-I747 using Tapatalk

In that other thread people were talking about having AP notch out a place for the probe.....is that something I need to ask for and if so would I have to be specific when I email Ali back about it?? I did get the divider....on a second note Rocky just shed perfect and Jack isnt far behind him!

Sent from my SCH-I535 using Tapatalk

Well i think alot of them have it in bottom already, but some ask for prob cut outs on each side.. If its not there a dremmel tool can easily cut you our a little insert for your probe.