New rack (pic, questions)

I was also thinking of drilling a hole into each shelf, above the rim of each tub; then sliding a nail into each one to act as a "pin." Mark suggested getting some clamps at the hardware store tomorrow; think we'll do that. I have binder clips but they're way too small!

Quote:

---

Originally Posted by TekWarren

Looks good for sure! Just an idea for concerns on the tub and edge of the rack... You could attach/screw/affix a piece of material to the edge of each shelf that you could rotate up or down. In the down state it would be the span one level and come down right in the middle to prevent the tub from moving outwards. Does that make sense? Think of clock hands and how they rotate, swing the latch up to pull a tub out and then swing it back down to "lock" the tub in place?

Anyway congrats on a step forward!

---

Like the pic I posted? LOL ;)

I guess :P I couldn't really tell if those where like lock/latches or just a swing down stopper which is what I was describing...sorry!

Quote:

---

Originally Posted by TekWarren

I guess :P I couldn't really tell if those where like lock/latches or just a swing down stopper which is what I was describing...sorry!

---

LOL, no biggie, was just funny. :rockon: My wording wasn't very descriptive.

So they should be OK as-is?

Quote:

---

Originally Posted by Ginevive

So they should be OK as-is?

---

Short term, I think they are fine. Sometime I would put the latch( aka turn-knob etc) in place, just to be certain. ;)