So I 'think' I have it straightened out. I'm guessing the reason for the erroneous readings were because the TStat wires were tangled w/ the UTH power cord possibly causing interference as the Herpstat instructions mention. I have since cleaned all that up and my Herpstat Output1 (cool side) is reading 100 on unit (temp gun shows 85.6 on floor) and Herpstat Output2 (hot side) is reading 101 on unit (temp gun shows 89.9 on floor). I'll adjust my cool side down to where it needs. I just wanted to see if I could control both sides.
Thanks for all the suggestions above! I'll fine tune those temps, add some substrate and hides, water dish for humidity and hopefully I'll be ready for my BP arrival the 1st of next week :)